DSC Power Series 설치 매뉴얼 - 페이지 5

{카테고리_이름} DSC Power Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC Power Series 14 페이지. Neo image sensor
DSC Power Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 매뉴얼 (18 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 지침 (2 페이지), 빠른 매뉴얼 (4 페이지), 설치 지침 매뉴얼 (11 페이지)

페이지 인쇄
DSC Power Series 설치 매뉴얼

RESETTING THE IMAGE SENSOR

There are two ways to reset the Image Sensor:
• Power Cycle – Power Cycle can be done by one of two ways: (1) Take out and reinsert batteries or (2) press and
release the sensor reset button. Only initiate a power cycle if the LED has not been active in the last 10 seconds.
After a power cycle, the Image Sensor will enter sensor power up state followed by the memory check state.
• Network Reset - An Image Sensor must be network reset when it has been previously enrolled on a different panel.
The Image Sensor will indicate that it is enrolled on a panel by blinking green after the memory check. In order to
perform a network reset, press and hold the reset button for a full 10 seconds or until the red LED flashes rapidly.
Release as sobon as you see the rapidly flashing red LED. A successful network reset will result in the LED blinking
https://answers.alarm.com/Installation_and_Troubleshooting/Image_Sensor/DSC_PowerSeries_Neo_Image_Sensor/DSC_PowerSeries_
Updated: Tue, 17 Apr 2018 13:46:31 GMT
5