DSC Power Series Installatiehandleiding - Pagina 5

Blader online of download pdf Installatiehandleiding voor {categorie_naam} DSC Power Series. DSC Power Series 14 pagina's. Neo image sensor
Ook voor DSC Power Series: Referentiehandleiding (2 pagina's), Handmatig (18 pagina's), Snelle referentiehandleiding (2 pagina's), Installatie-instructies (2 pagina's), Beknopte handleiding (4 pagina's), Handleiding voor installatie-instructies (11 pagina's)

RESETTING THE IMAGE SENSOR

There are two ways to reset the Image Sensor:

• Power Cycle – Power Cycle can be done by one of two ways: (1) Take out and reinsert batteries or (2) press and

release the sensor reset button. Only initiate a power cycle if the LED has not been active in the last 10 seconds.

After a power cycle, the Image Sensor will enter sensor power up state followed by the memory check state.

• Network Reset - An Image Sensor must be network reset when it has been previously enrolled on a different panel.

The Image Sensor will indicate that it is enrolled on a panel by blinking green after the memory check. In order to

perform a network reset, press and hold the reset button for a full 10 seconds or until the red LED flashes rapidly.

Release as sobon as you see the rapidly flashing red LED. A successful network reset will result in the LED blinking

https://answers.alarm.com/Installation_and_Troubleshooting/Image_Sensor/DSC_PowerSeries_Neo_Image_Sensor/DSC_PowerSeries_

Updated: Tue, 17 Apr 2018 13:46:31 GMT