AirTight SS-300-AT-C-50 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} AirTight SS-300-AT-C-50에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTight SS-300-AT-C-50 4 페이지. Access point/sensor

Getting SS-300-AT-C-50 Online

Step 1:

Power up

If using PoE, plug one end of the Ethernet cable into the

PoE switch or injector and plug the other end into the

LAN + PoE port

(marked as LAN1)

SS-300-AT-C-50.

Make sure the PoE source you are using is turned ON.

If not using PoE, insert the power adapter plug into an

AC power outlet and the other end into the power

input port on the SS-300-AT-C-50.

Warning:

If not using PoE, make sure you use only the AC power adapter that came in the package

to power up the SS-300-AT-C-50.

Step 2:

Connect to the network

If you are using PoE, then SS-300-AT-C-50 should

already be connected to your network. If you are

not using PoE, then plug one end of the Ethernet

cable into an Ethernet jack on your network and the

other end into the LAN port

the SS-300-AT-C-50.

Warning:

Make sure you plug the Ethernet cable only into the LAN1 port and not into the LAN2 port or

into the Console port

Step 3:

Check the LED status

Wait for a few minutes till the three LEDs for Power,

LAN and Wi-Fi turn GREEN, which indicates that

the SS-300-AT-C-50 is online and operational.

on the

(marked as LAN1)

With PoE

LAN 1

(Ethernet + PoE)

Power

LAN

Wi-Fi

Without PoE

Console

LAN 2

(Ethernet Only)