AirTight SS-300-AT-C-50 Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy AirTight SS-300-AT-C-50. AirTight SS-300-AT-C-50 4 stron. Access point/sensor
Drukuj stronęGetting SS-300-AT-C-50 Online
Step 1:
Power up
If using PoE, plug one end of the Ethernet cable into the
PoE switch or injector and plug the other end into the
LAN + PoE port
(marked as LAN1)
SS-300-AT-C-50.
Make sure the PoE source you are using is turned ON.
OR
If not using PoE, insert the power adapter plug into an
AC power outlet and the other end into the power
input port on the SS-300-AT-C-50.
Warning:
If not using PoE, make sure you use only the AC power adapter that came in the package
to power up the SS-300-AT-C-50.
Step 2:
Connect to the network
If you are using PoE, then SS-300-AT-C-50 should
already be connected to your network. If you are
not using PoE, then plug one end of the Ethernet
cable into an Ethernet jack on your network and the
other end into the LAN port
the SS-300-AT-C-50.
Warning:
Make sure you plug the Ethernet cable only into the LAN1 port and not into the LAN2 port or
into the Console port
Step 3:
Check the LED status
Wait for a few minutes till the three LEDs for Power,
LAN and Wi-Fi turn GREEN, which indicates that
the SS-300-AT-C-50 is online and operational.
on the
(marked as LAN1)
on
With PoE
LAN 1
(Ethernet + PoE)
Power
LAN
Wi-Fi
Without PoE
Console
LAN 2
(Ethernet Only)