DSC Power Series 설치 지침

{카테고리_이름} DSC Power Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC Power Series 2 페이지. Neo image sensor
DSC Power Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 매뉴얼 (18 페이지), 빠른 참조 매뉴얼 (2 페이지), 설치 매뉴얼 (14 페이지), 빠른 매뉴얼 (4 페이지), 설치 지침 매뉴얼 (11 페이지)

페이지 인쇄

Installation Instructions

The PC5200 can be used to provide up to 1.0A of additional current to the

PC50X0 control panel (see PC50X0 Installation Manual for complete installation

instructions). The PC5020 v3.1 supports up to four PC5200 modules.

Specifications

• Module Current Draw: 20mA

• Auxiliary Current: 1.0A continuous rating; 3.0A short term if backup battery

connected (PTC-protected - fuseless design)

• Transformer requirements: 16.5V, 40VA

• Battery requirements: 4Ah minimum

Terminal Descriptions

AC - The PC5200 requires a 16V, 40VA transformer. Connect the transformer to

an unswitched AC source and connect the transformer to these terminals.

AUX

AUX - This terminal is used to provide power for devices. Maximum current

draw is not to exceed 1.0A continuous or 3.0A short term (with a backup

battery connected).

TAM - This can be used to tamper the cabinet the PC5200 is mounted in.

Connect a normally closed (NC) switch across TAM and BLK. If the tamper is

not being used connect a piece of wire across TAM and BLK to remove the

trouble condition.

Keybus- The 4-wire Keybus connection is used by the panel to communicate

Keybus

with the module. Connect the RED, BLK, YEL and GRN terminals to the RED,

BLK, YEL and GRN Keybus terminals on the PC50X0 control panel.

PC52OO

v2.O

Power Supply Module