3M-Matic S867 L-Clip Applicator 지침 및 부품 목록 - 페이지 3
{카테고리_이름} 3M-Matic S867 L-Clip Applicator에 대한 지침 및 부품 목록을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M-Matic S867 L-Clip Applicator 6 페이지. 10500;29500
페이지 인쇄Installation
(Continued)
6. Cut air line number 17 on the flow control valve
approximately 1 inch [25 mm] down from the L-
fitting as shown in Figure 4. Note that the
position of air line 17 on the S867 is different than
its position on the S857.
7. Reinstall the T-fitting as shown in Figure 5 by
pushing the tubing into the fitting as far as it will
go.
8. Close and latch side cover on the applicator and
connect main the air supply line to the applicator.
9. Turn on the L-clip applicator air valve to On. Turn
the U-clip attachment ball valve to On so that the
valve handle aligns with the tubing. Check for air
leaks.
Operation
1. Turn the S867 applicator main air on/off valve to
On.
2. Turn the U-clip attachment ball valve to On so
that the valve handle aligns with the tubing.
3. Hold down and push carton against applicator
box paddle to apply a U-clip. The applicator
applies an L-clip of tape to bottom and edge of
carton. The U-clip attachment automatically
buffs the top leg of the tape down onto the top of
the carton.
4. To convert applicator back to L-clip operation,
turn off U-clip attachment ball valve, unscrew and
remove mounting bracket and attach to left side
of the applicator for storage as shown in Figure 6.
Figure 4—Air Line #17
Figure 5—Reinstall T-Fitting
Figure 6—Remove Mounting Bracket