AirTight 60403 운영자 매뉴얼 - 페이지 4
{카테고리_이름} AirTight 60403에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTight 60403 4 페이지. 12v led digital tire inflator
페이지 인쇄
NOTICE
The ON/OFF button can be
used to override the preset pressure
value if required.
8. To operate lights, toggle switch from
the "OFF" position to either the "Light",
TROUBLE SHOOTING
INFLATOR DOES NOT WORK WHEN
SWITCHED TO "ON"
• Power cord may not be plugged in
completely. Check the connection.
• Check vehicle power outlet and power
plug terminals for dirt. Use a non-
conductive probe, not fingers or metal, to
clean.
• Check to see if the pre-programmed
pressure is set to a lower PSI than your
tire currently is reading (i.e., the digital
gauge is set to 15 psi but your tire is at
2o psi; in this scenario, the inflator will
not turn on) Refer to the digital gauge
operating instructions and set the PSI to
the correct tire pressure.
• Check vehicle power outlet fuse, which
should be a minimum of 15 Amps.
• Fuse may have blown. Check fuse in
power plug adaptor and replace if
P.O. Box 88259 Tukwila, WA 98138 • © 2011 Wilmar Corporation
All rights reserved • airTIGHT™ is a trademark of Wilmar Corporation
"Flash" or "SOS" positions for desired
lighting.
9. Unplug the power cord from 12V DC
power outlet.
necessary with one of the same
amperage. NEVER replace a blown fuse
with a fuse having a higher rating.
UNIT IS RUNNING BUT TIRE IS NOT
INFLATING
• Check that the air hose connector is
attached properly to the tire valve stem.
• Check for tire leaks or damage, and
check air hose for breaks and leaks at
fittings.
INFLATOR FEELS HOT OR RUNS
SLOWLY
• Unit may have overheated. Shut the unit
off and allow to cool for 20-25 minutes.
• NEVER use this inflator for more than
10 minutes continuously.
• Voltage may be too low. Check
condition of vehicle battery.