DSE DSE705 운영 매뉴얼 - 페이지 6

{카테고리_이름} DSE DSE705에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSE DSE705 13 페이지. Ats control module

3 CONFIGURATION INSTRUCTIONS

♦ With the unit in Auto

switch on the rear, left-hand edge of the PCB. This is partially hidden to prevent accidental

operation.

Normal

Configuration

♦ Once Configuration Mode is selected, the 'Auto' LED will commence rapid flashing, and all

normal operation is suspended.

♦ The Run On Load

the required function. The 5 left-hand LED's will form the code. See configuration table over

leaf.

♦ The Run Off Load

right-hand LED's inform the user of the current setting for the chosen function. See

configuration table over leaf.

♦ When the required parameters are displayed, pressing the Auto

the new setting, and the process is repeated for each function change.

♦ When configuration is complete, the Configuration Mode Selector Switch should be returned

to the 'Normal' position.

- 6 -

057-043 705 Operating Instructions Issue 1.1 18/06/2007

705 ATS controller operators manual

mode, Configuration Mode is selected by operation of a small

pushbutton can be used to select the LED 'code' that corresponds to

pushbutton will allow the user to change the associated value. The 3

Parameter

button will save

Value