DSG Technology AA9604 운영 매뉴얼 - 페이지 8

{카테고리_이름} DSG Technology AA9604에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSG Technology AA9604 20 페이지. Auto attendant

Chapter 2 Installation

2-1 Installation Procedures

This chapter tells you how to install AA9604 Auto Attendant. To make the install

process easier and more efficient, we recommend reading the entire chapter from

start to end, following all the steps.

Plug the factory-supplied 110V~220V/12V power adapter into power jack on

the rear panel of the system, and the 2-prong of the adapter into a power

outlet. (As shown in Figure 2-1) The power indicator on the front panel will

be lit.

Plug one ends of the two factory-supplied telephone lines to the RJ-11 jack

labeled LINE1, LINE2, LINE3 and LINE4 on the rear panel, and the other

ends of the telephone lines to the appointed extensions of the PBX. (As

shown in Figure 2-1)

(Optional) The system provides an external DC 12V battery connector. As

shown in Figure 2-1, connect one end of battery DC 12 volts wires to the

DC12V socket, and the other end to a battery. Please beware of the current

polarity (positive inside, negative outside) when connecting the battery.

When power failure occurs, the battery should supply the power

automatically, to maintain the operation of the system.

Make sure the SECURITY/NORMAL switch on the front panel is in upper

position (NORMAL mode) before program the system. You will not be able

to enter the programming mode if the switch is in SECURITY mode.

Figure 1: The System Installation Layout

AA9604 is capable of linking to all kinds of PBX. Please read the following before

you start.