ATS Diesel Performance Aurora Plus - 5000 설치 매뉴얼 - 페이지 10

{카테고리_이름} ATS Diesel Performance Aurora Plus - 5000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATS Diesel Performance Aurora Plus - 5000 18 페이지. Aurora plus - 5000 turbo kit (2003-2007) 5.9l dodge

페이지 인쇄

16. Make sure the Wastegate control rod is aligned correctly as shown. The

picture below shows the factory turbo ready to be used on the Aurora Plus

system.

Installing the Aurora Plus – 5000 Compound System

1. Remove the plug from the auxiliary oil drain port located on the side of the

engine block just above the oil pan on the passenger side. Use a hammer

and a flat tip punch to turn the plug by tapping it on one side. Do not hit

the plug in the center. Once turned, grab the exposed plug edge with a

set of vise-grip pliers and remove it from the engine block.

2. Once the factory turbo and ATS manifold are installed, there is not

enough room to get the Aurora 5000 installed in the proper location

without removing the battery. To avoid having to remove the battery, set

the Aurora 5000 charger into the passenger side of the engine

compartment. Rest the turbo on the frame in a secure position.

3. Place the ATS 3-piece manifold onto a work bench. Install the factory

turbo on the ATS manifold using the provided turbo flange gasket (Figure

1, #27). The factory turbo does not provide much clearance for the inner-

rear nut. A standard nut (Figure 2, #2) with a serrated washer provides

Aux. Oil Drain Port