DSP ULE Starter Kit 사용자 설명서 - 페이지 12

{카테고리_이름} DSP ULE Starter Kit에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSP ULE Starter Kit 17 페이지.

4.4 Messages from ULE Node to Controller

The Alert On, Alert Off, Tamper, Keep Alive, On/Off/Toggle, Raw Fun messages are all items that

are sent over the link from the Node to the Controller. To send any of these messages you:

1) Select Message

2) Click Generate Button and note command generated

3) Press the Send button. This should generate an MCU < -- > CMND exchange in the VAR log

window and an incoming message in the Controller GUI log window

Alert On example is shown below:

1) The command generated by the VAR

2) The MCU < --- > CMND exchange on the Node Side. The CMND informs the MCU that it

received an ACK from the ULE Controller

3) The incoming message as seen on the graphical Log on the ULE Controller side:

4) The incoming message as seen parsed in the Log File on the ULE Controller side (This *.txt

file is located in the same directory as the DSPG Test Application.exe file):

28-05-2015 13:40:03:607 (1432809603607)

Target ---> Host: 29 00 00 00 16 30 21 00 00 30 17 00 01 00 00 00 00 02 00 00 00 03 01 00 00 01

01 06 00 02 04 00 00 00 01 00 0F 02 00 A5 FC

{CMBS_EV_DSR_HAN_MSG_RECV(12310)}

<CMBS_IE_HAN_MSG(12288)>:

Src: (type = 0, dev_id = 1, un_id = 0)

Dst: (type = 0, dev_id = 0, un_id = 2)

Transport : 0

Msg Sequence : 3, Message Type : 1

IF Type : 0, IF Id : 0x100, IF Member : 1

Data Len: 6

Alert Off, Tamper, Keep Alive, On/Off/Toggle work similarly to the example above.

Rev1.0

ULE Starter Kit User's Manual

June 2015