DSPeaker Anti-Mode 8033S-II 사용자 설명서 - 페이지 12
{카테고리_이름} DSPeaker Anti-Mode 8033S-II에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSPeaker Anti-Mode 8033S-II 20 페이지. Automatic subwoofer equalizer
페이지 인쇄
4. Basic operation
4.1. Bypass mode
If you want to compare the corrected and uncorrected operation, press the
PWR
BYPASS
BYPASS button quickly. This will switch between bypass and normal mode. The
LIFT 25
LIFT 35
first press will put Anti-Mode into bypass mode, which is also indicated by the
BYPASS LED being lit. If the Bypass mode is already active, the unit switches back to normal
mode. In bypass mode no room corrections are active and user selected lifting EQ is turned off.
Low-pass or dipole corrections remain active in bypass mode (8033S-II only).
4.2. Lifting EQ
The LIFT button switches between the EQ settings of Anti-Mode 8033. The settings are stored with
a longer press of the LIFT button. A brief sound heard from the subwoofer after settings have been
stored indicates that you should release the LIFT button.
4.2.1. Flat
The first EQ setting is "flat" or no lifting. Neither the LIFT25 nor LIFT35 LED are lit.
PWR
BYPASS
In this setting, the target response is flat from 5Hz to 160Hz (8033 cinema) or
LIFT 25
LIFT 35
250Hz (8033S-II). This setting is automatically changed to Subsonic-Filter-Only
after the first (main) calibration. You can override this and save the new setting.
4.2.2. Lifting 15-25Hz
The second EQ setting is LIFT25. When the LIFT25 LED is lit, Anti-Mode boosts
PWR
BYPASS
frequencies between 15 and 25Hz (max. 8dB at 20Hz). This will also activate a
LIFT 25
LIFT 35
digital infrasonic filter, which will filter out frequencies below 10Hz, which can be
dangerous to ported subs without proper protection.
4.2.3. Lifting 25-35Hz
The third EQ setting is LIFT35. When LIFT35 LED is lit, Anti-Mode boosts
PWR
BYPASS
frequencies between 25-35Hz (max. 8dB at 30Hz). As with LIFT25, the digital
LIFT 25
LIFT 35
infrasonic filter is also activated.
Rev. 2.0
A
-M
NTI
18.06.2012
8033
/ 8033S-II
ODE
CINEMA
Page 12 (20)