Attero Tech Dante unDX2IO+ 사용자 설명서 - 페이지 14
{카테고리_이름} Attero Tech Dante unDX2IO+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Attero Tech Dante unDX2IO+ 16 페이지. 4 x 2 wallplate
페이지 인쇄3.2 – Software Control
The unDX2IO+ device parameters such as preamp control and input switching are fully supported in Attero Tech's unIFY
Control Panel software (V2.2 or later). Refer to the Help documentation within the unIFY application for support.
3.3 – 3
Party Control
rd
The unDX2IO+ supports 3
rd
power, mic/line gain options and control of presets.
There are two control interface types available for the unDX2IO+. The first type is a Dante proprietary interface (-C) which
is typically used by devices already that have built-in support for Attero Tech devices. The second type supports a 3
party UDP interface (-U) and is available to anyone to use with any device capable of sending and receiving UDP messages.
Information on the commands the unDX2IO+ supports as well as details of how to use the 3
found in the unIFY 3
party Software API document, available from the registered users section of the Attero Tech website
rd
(Go to
www.atterotech.com
3.4 – Control Interface Type
The type of control interface a specific unDX2IO+ supports is defined by the Dante firmware it has been loaded with.
Refer to the Help documentation within the unIFY Control Panel software for details on how to determine the control
interface type that your device actively supports.
A devices initial control interface is chosen when ordering the unit. However, it can be easily changed though once the
unit is in the field by updating the device's Dante firmware. The tools and necessary firmware files for updating a device's
control interface can be obtained from the registered users section of the Attero Tech website (Go to
and click on the log-in option). The firmware files have an extension .DNT (otherwise known as "donut" files) and there is
one for each control interface type.
3.4.1 – Using the Command interface
In order to make use of the control interface, regardless of type, the unDX2IO+ and the controlling device need to be on
the same physical subnet and need to have IP addresses in the same range. The control devices should then be able to
converse with the unDX2IO+ without any further configuration necessary.
If control device is on a separate network to keep the Dante traffic separate, remote control of the unDX2IO+ can still be
achieved by using Attero Tech's CommandHub product (see the Attero Tech website for more details).
party control allowing external system to manage the unDX2IO+'s settings such as phantom
and click on the log-in option).
Attero Tech, LLC
1315 Directors Row, Suite 107, Ft Wayne, IN 46808
Phone 260-496-9668 • Fax 260-496-9879
www.atterotech.com
614-00036
unDX2IO+
User Manual
party UDP interface can be
rd
www.atterotech.com
rd