Attero Tech AXON D2FLEXio 사용자 설명서 - 페이지 6
{카테고리_이름} Attero Tech AXON D2FLEXio에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Attero Tech AXON D2FLEXio 11 페이지. Dual analog flex i/o networked audio interface
페이지 인쇄2.1– Mounting
It is recommended that the unit be secured to a flat
surface with a screw through each mounting flange.
Dimensions for mounting are show in the Figure 3
below. Use a No. 6 screw of a type and size that is
applicable to the surface to which the D2FLEXio will be
attached.
Notes for mounting: All connections to the D2FLEXio
should be made before the power is applied.
Attach any audio sources that will be used. The
o
I/O terminals are balanced so be sure to check
what I/O type the source or destination to be
connected uses. In order to find how to connect
it
correctly
(see
section).
When powering using PoE:
Attach the Dante™/AES67 port to a spare PoE-
o
enabled port on a PoE switch using a CAT-5e
cable. If a mid-span injector is being used,
connect a spare input port to the network
switch using a CAT-5e cable, and then connect
the
corresponding
Dante™/AES67 port of the D2FLEXio.
When powering using an optional external supply:
Attach the Dante™/AES67 port to a spare port
o
on the network switch using a CAT-5e cable.
Attach the power supply to the power input
o
jack and then power up the external supply.
If all steps are performed correctly, the Status LED
should be lit.
There may also be some activity on the D2FLEXio
Dante™/AES667 Ethernet connector LED indicators. With
no Dante™/AES67 network, both LEDs will remain off. If
an active connection is made both LEDs will come on and
if there is network activity, the yellow LED will then flash.
*Note:
CAD drawings can be downloaded from the
Attero Tech website. Please contact Attero Tech for any
further
product
related information that
accessible on the website.
Hardware
Connections
output
port
to
the
is
not
1315 Directors Row Suite 107 Fort Wayne, IN 46808 ⁞ (260)496-9668 ⁞ www.atterotech.com
Figure 4- Dimensional Drawing
Page 3