Attero Tech CommandHub 사용자 설명서 - 페이지 6

{카테고리_이름} Attero Tech CommandHub에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Attero Tech CommandHub 20 페이지. Unify proxy device for control and routing

2 – Installation

Dante network Ethernet port

Control network Ethernet port

*Note: The CommandHub has many other ports than listed above but only the two Ethernet ports are required. The

other ports and connections can safely be ignored.

The CommandHub can be mounted in several locations. The unit can sit on top of a table or shelf. There are also

mounting holes on the underside allowing the CommandHub to be permanently mounted on virtually any surface and in

any orientation. The unit can even be simply hung off a spare power outlet!

*Note: All wiring connections to the CommandHub should be completed before applying power to it.

2.1 – Supplying Power

The CommandHub comes with a power module that can be detached. The CommandHub can either run with the power

module attached or the power module can be separated and used as a separate power supply.

To power the CommandHub with the power module attached to the main module, fit the figure-8 power adapter to the

power module and use the figure-8 mains cable from the mains outlet to the CommandHub.

Further power options are provided if the power module is separated from the main module, with a DC power cable

(supplied) then used to connect the two modules together. The power module can then either be used as a wall wart by

attaching the mains adapter to it and plugging it directly into a mains outlet, or as a brick-type supply by attaching the

figure-8 power adapter and using the figure-8 power cable to connect to the mains outlet.

*Note: The CommandHub also includes blanking plates to cover the unused connections if the power and main module

are separated.

Figure 1 – CommandHub Connectors and Indicators

Page 5

CommandHub

User Manual

614-00019-01