3onedata ES5026 사용자 설명서 - 페이지 16

{카테고리_이름} 3onedata ES5026에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3onedata ES5026 20 페이지. Gigabit managed poe switch

User manual

Picture 5.5.3.1 Configuration of Port Isolation

5.5.4 Loop Protection

Picture 5.5.4.1 Loop Detection

There are two Loop protection modes: Off and Loop Protection, the default configuration is Loop Protection mode.

When there is a loop detected, the related port will be blocked and port indicator will be red on,and the buzzer will

alarm.

Picture5. 5.5.1 PoE Config

This page allows users to configure PoE features.

Enable Bar: users can select from " Enable or Disable" in the Enable list, if "Disable" selected, the PoE power

supply will be cut off;

Priority Bar: users can select from Priority List three priority levels " Low/ Middle/High" , specific ports can be

configured as power supply priorities. The priority ports can get normal power supply when the PoE power supply

is overloaded;

Current(mA) Bar: the output currents of specific ports are showed;

Voltage(V) Bar: the output voltages of specific ports are showed;