DT SWISS 240 OVERSIZE 기술 매뉴얼 - 페이지 11

{카테고리_이름} DT SWISS 240 OVERSIZE에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT SWISS 240 OVERSIZE 14 페이지.

5. Put the disassembly tool onto the axle.

6. Put the installation cylinder onto the bearing.

→ The disassembly tool centers the installation

cylinder on the axle.

7. Tap the bearing into the hub shell with slight

hammer strokes.

8. The lower installation cylinder must rest on a flat

surface.

9. Remove the installation cylinder from the hub.

10. Fit the non drive side of the hub onto one of the

two installation cylinders.

11. Place lightly greased ball bearing on the axle on

the drive side.

12. Drive the second bearing into the hub shell with

slight hammer strokes.

→ The lower installation cylinder must rest on a

flat surface.

13. Remove both installation cylinders from the hub.

240 Oversize [screwed end caps]