Attop W10 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Attop W10에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Attop W10 6 페이지.
페이지 인쇄(3) Trimming on the flying actions
When the drone drifts to the forward / backward / left or right side unintentionally,
you can correct it by press vertically and keep the Left Control Stick, you will
hear "beep" to enter Trimming mode, then push the Right Control Stick in the
opposite direction until it evens out. Please release the Left Control Stick after
trimming completion.
Left Control Stick
(4) 360° Flip
Fly the drone to a height over 6 feet, then press the Right Control Stick vertically
to activate 360° Flip function. Now you hear "beeps", and then move the Right
Control Stick to flip the drone accordingly.
Right Control Stick
Notes:
.
There are continuous beeps from the remote when you activate this function. If you do not move the
Right Control Stick approx 5 seconds after press the Right Control Stick vertically, the function will
be cancelled and the remote will stop beeping.
.
This function can't be activated when the battery of the drone is low power.
(6) Photograph and Video
To take photo, short press
To take video, press and hold the
"take video", press and hold this button again approx 2 seconds to finish
and save the video.
Please make sure to open the App on your smart phone before using it,
then you can review the videos taken in the media file of App.
9.End of the flight
.
When the flight is finished, please power off the remote controller and make
.
it into a habit to avoid any damage.
When the flight is finished, please have a long press on the power switch for
2 seconds to shut off the power of the drone, and make it into a habit to
remove the battery from the aircraft to avoid any damage.
10.How to change the propellers
The front of drone
Clockwise
Counterclockwise
A
B
B
A
Counterclockwise
Clockwise
Right Control Stick
8
button as picture.
button approx 2 seconds of
Take Photos / Video
.
.
All drones have two rotors that spin clockwise
and two rotors that spin counter-clockwise.
Make sure to place the propellers on the correct
.
axis or they will not spin correctly and the drone
will not lift.
Each propeller is marked on its underside with
.
A or B. There may be a number after the letter
but you can ignore the number.
Make sure to follow the graphic as above to see
where to place the propellers.
10
(5) One Key Return
The remote toward the tail of drone and press the
will fly toward its back following a path parallel to remote direction. The LEDs
on the drone keep flashing when the drone is returning.
Press the
button again or move the Right Control Stick, forward to cancel
this function, or the drone will keep flying back.
Note: Please deactivate Headless function and make sure the remote
toward the tail of drone before activate the Return function.
One Key Return
11.Flight safety
Fly in
Strong
Open Areas
GPS Signal
Avoid flying over or near obstacles, crowds, high voltage power lines, trees or
bodies of water.DO NOT fly near strong electromagnetic sources such as power
lines and base stations as it may affect the onboard compass.
DO NOT use the aircraft in adverse weather conditions such as rain, snow, fog
and wind speeds exceeding 10 m/s or 22 mph.
Stay away from the rotating
propellers and motors.
button, then the drone
9
Maintain
Fly Below
Line of Sight
400 feet (120 m)
No Fly Zone
11