Attop W10 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Attop W10에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Attop W10 6 페이지.
페이지 인쇄4. Remote controller
（1）
（3）
（2）
（4）
（5）
（6）
（7）
（8）
（9）
（10）
5. Preparing to fly
(1) Switch on the power
Switch on the drone
ATTENTION: Please finish the aboved 2 steps within 10 seconds!
1. Hearing a beep from controller, and the LEDs of drone stop flashes,
mean is automatic syncing success between Drone and Controller.
2. Now, the drone is contolled by Controller, the smart phone APP could not
control the drone.
Please place the drone onto a flat surface before Switch on the
drone power!
6.Using the remote controller
Left Control Stick
Ascend / Descend
Turn left / Turn Right
7. Toss to taunch
After frequency matching and calibration finished, you can hold the aircraft
in your hand, and then horizontally throw it out. The aircraft will automatically
unlock the blades and fly in the air.
Note: It is better to operate the calibration step again after operating
Throw to fly for several times. The function will be more stable.
（1）Antenna
（2）Left Control Stick
（3）Right Control Stick
（4）Power Button
（5）One Key Take Off / Landing
（6）Headless Mode
（7）Mobile Device Holder
（8）One Key Return
（9）Take Photos / Video
(Please make sure to open the App on your smart
phone before using it, then you can review the
videos taken in the media file of App.)
（10）Battery case
Switch on the Remote
4
Right Control Stick
Forward / Backward
Left Side / Right Side
6
(2) Calibration
(3) Unlock the aircraft for take-off
After calibration succeed, Push the Left Control Stick up and then release
(OR push the Left Control Stick to the lowest left, and meanwhile push the
Right Control Stick to the lowest right), the rotors start rotating slowly, which
means motors unlock succeed. Release Control Stick and push the Left
Control Stick slowly to take off the drone.
（4）One Key Take off / Landing
Or After unlock the motors, press
take off automatically.
When flying in the air, press
automatically.
One Key Take off / Landing
In case of emergency status, Press and Hold
the
immediately stop functions and drop off.
8. Aircraft functions
(1) Speed mode
Press the Left Control Stick to change the speed mode when flying.
The default speed is the most slowly one, when press one time you will hear
"beep beep", then go into the second speed acceleration, and press again with
"beep beep beep" to the final fastest speed. Totally 3 speeds and repeat by
pressing the button.
Remark: Beginners would be suggested to use the default speed firstly to
play until skillful.
Left Control Stick
(2) Headless mode
Headless Mode: When the head of drone torwards the front, press
to activate Headless function.The drone will fly according to the controlled
direction on remote, no matter which direction the head of drone torwards to,
it will fly according to your controlled direction on remote controller.
Press
button again to deactivate Headless function.
Note： Please make sure head of drone torwards the front and remote
torward to the tail of drone before activate Headless function.
Place the drone onto a flat surface and push
the Left and Right Control Stick as the image
and the controller would make a sound "beep".
The LEDs of drone are flashing, and then stop
flashing, that means calibration succeed.
OR
button to land
Emergency Stop
button about 2 seconds, the drone will
5
Headless mode
7
button to
button