DTF Maxima Semi-Auto 사용자 설명서 - 페이지 5

{카테고리_이름} DTF Maxima Semi-Auto에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DTF Maxima Semi-Auto 7 페이지. Dual heat press

페이지 인쇄
DTF Maxima Semi-Auto 사용자 설명서

TROUBLESHOOTING

PROBLEMS
Distance between 4
sides of top plate and of
bottom plate not uniform
Pressure too high or low
No countdown/timer
When time is up, press
does not press
No temperature control
SOLUTIONS
1.
Use a ruler to measure whether the distance
between the 4 sides of both platens is
consistent. If not, screw "down" nut in the
center of the heating plate to adjust.
1.
Ideal pressure is about 60psi. Adjust filter.
2. Lift the upper regulating valve in the "+"
direction to increase pressure, or in the "-"
direction to reduce pressure.
3. Check whether pressure of air compressor is
within ideal range of 85-100psi.
1.
Make sure machine head is in proper place.
2. Check proximity switch and distance. Adjust
to less than 5mm.
1.
Check circuit (intermediate relay)
1.
Check whether temperature control table,
solid state relay, and heating plate circuit
are in good contact. Also check to ensure
the electrical components are functioning
properly.
6