DTF Maxima Semi-Auto Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DTF Maxima Semi-Auto. DTF Maxima Semi-Auto 7 pagina's. Dual heat press
Pagina afdrukken
TROUBLESHOOTING
PROBLEMS
Distance between 4
sides of top plate and of
bottom plate not uniform
Pressure too high or low
No countdown/timer
When time is up, press
does not press
No temperature control
SOLUTIONS
1.
Use a ruler to measure whether the distance
between the 4 sides of both platens is
consistent. If not, screw "down" nut in the
center of the heating plate to adjust.
1.
Ideal pressure is about 60psi. Adjust filter.
2. Lift the upper regulating valve in the "+"
direction to increase pressure, or in the "-"
direction to reduce pressure.
3. Check whether pressure of air compressor is
within ideal range of 85-100psi.
1.
Make sure machine head is in proper place.
2. Check proximity switch and distance. Adjust
to less than 5mm.
1.
Check circuit (intermediate relay)
1.
Check whether temperature control table,
solid state relay, and heating plate circuit
are in good contact. Also check to ensure
the electrical components are functioning
properly.
6