DTI HV-500 기술 설명 - 페이지 13
{카테고리_이름} DTI HV-500에 대한 기술 설명을 온라인으로 검색하거나 PDF를 다운로드하세요. DTI HV-500 18 페이지.
페이지 인쇄
HV-500 TECHNICAL DESCRIPTION
PC CONNECTION AND CONTROL
You can connect the inverter with a USB to RS-232 adapter (for example: ATEN UC232A) to the PC, where
the inverter can be parameterized. Use the „H" connector 5. and 13. pins and ground to common
potential. The DTI Tool software can be run on the PC.
The DTI Tool compatible with windows 10 x86 or x64.
If you would like to use another operating system, please contact us
DTI Tool features:
•
Real time data analysis
•
Online data logging just with DTI Tool
•
Error checking and logging
•
Motor position sensor setup, inspection
•
Online motor control with keypad (very carefully)
•
Setting input parameters
•
Very detailed query of measured current and voltage (like oscilloscope)
WIRING
Analog and digital signal inputs and outputs are provided for switches, sensors, contactors, hydraulic
valves, CAN communications, RS232 communications and SSI communications.
The wiring must be carried out by a qualified person.
It must be paid attention to the equipotential bonding for components which are connected to the unit
and which do not have isolated inputs and outputs (equalizing connection GND). The equalizing currents
may destroy components and parts.
The units, the inductive and capacitive accessories as well as the power wiring can generate strong
electric and electromagnetic fields. These fields may be dangerous for persons having electronic medical
aids or appliances (e.g. cardiac pacemakers). Sufficient distance to these electrical parts must be
observed. The switch cabinet must be labeled accordingly.
Keep all wiring harnesses short and route wiring close to vehicle metalwork. Keep all signal wires clear of
power cables and consider the use of screened cable. Keep control wiring clear of power cables when it
carries analogue information - for example, accelerator wiring. Tie all wiring securely.
Do not apply power until you are certain the controller high power and signal wiring is correct and
has been double checked. Wiring faults will damage the controller.
Revision 1.31
(BETA
VERSION)
13