ATV VD650WDR 사용 설명서 - 페이지 12

{카테고리_이름} ATV VD650WDR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATV VD650WDR 18 페이지.

8) Entrance : Entrance counting mode. The object move in through the entrance,

counting number increases.

 Size : Press Enter button adjust the size of the Entrance zone.

 Posi : Press Enter button adjust the Position of the Entrance zone.

 Alarm Cnt : Set alarm out entrance count. Alarm count number is delaying

number before output alarm.

 Reset Cnt : Entrance count reset.

Crossing object is not considered. / Several objects will not be detected.

If the distance is increases between the camera and entrance, the result can be

inaccuracy.

The distance is too long

1) Sharpness : Adjust sharpness of outlines (0~15)

2) Resolution : Select high resolution mode (Low/Mid/High)

3) 2D-NR : Select 2D noise reduction level (0~6)

 2D-NR : Noise reduction on a frame

4) 3D-NR : Select 3D noise reduction level (0~31)

 3D-NR : Noise reduction through the several frame

5) DNR Demo : Select DNR Demo Display On/Off using the Left and Right Buttons

1) d-Effect(Digital Effect) : Select digital Flip/Rotate state (Off/Rotation/Mirror/V Flip )

2) Nega : Select negative color state(on/off)

3) d-PTZ (Digital Pan, Tilt, Zoom) : Adjust d-PTZ.

 Func : Press the Enter button to turn digital zoom on/off.

 Zoom : Use the Left and Right buttons adjust to digital zoom(0-255).

 Pan&Tilt : Press the Enter button to access the Pan&Tilt.



Use the Left and Right buttons adjust to digital pan

Several Object

Crossing Object

None DNR Effect

Display

Camera Installed at the ceiling

Crossing object is none

One object is passing.

DNR Applied

Display