dtm Azymut 설치 및 운영 매뉴얼 - 페이지 4

{카테고리_이름} dtm Azymut에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dtm Azymut 8 페이지. Wireless gate state sensor

MONTAGE

The AZYMUT sensor is designed to work with the FLEX receiver. It can be mounted on gates of any

type.

The distance between the AZ-MG magnet and the AZ-TX transmitter with the gate

closed should be in the range of 1-30 cm

Pay attention to the arrows on theAZ-TX transmitter board!

The AZ-TX transmitter must be mounted perpendicular with the arrows pointing to

the front wall of the AZ-MG magnet when the gate is closed. If necessary, reverse the

fixing of the plate in the transmitter housing (Fig.2).

Fig.2 Mounting the AZ-TX transmitter relative to

AZ-MG magnet.

Installation of theAzymut sensor in various types of gates:

Garage door

1. Mount the AZ-FLEXRX receiving module in the FLEX receiver (Fig. 3). Set the input in the signaling

mode in the FLEX receiver menu - 'Sr.St = on' option (see the FLEX receiver manual).

2. Mount theAZ-MG magnet on the gate and theAZ-TX transmitter on the wall (or vice versa) in such

a way that the magnet and the transmitter are on one level when the gate is closed (Fig. 4).

Fig.3 Installation of the AZ-FLEXRX receiving

module in the FLEX receiver.

Fig.4 Mounting the sensor on the garage door.

2x10-pin module

socket in the FLEX

receiver