DTM System GALACTIC NANO 868 설치 매뉴얼 - 페이지 2
{카테고리_이름} DTM System GALACTIC NANO 868에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DTM System GALACTIC NANO 868 4 페이지. One channel radio receiver
페이지 인쇄1. Installation
Receiver designed for use inside buildings or inside other automation equipment. Ensure proper working
conditions in line with technical parameters. Do not mount in locations exposed to high humidity and frequent
sudden changes of temperature.
Due to externally accesible screw connection provide galvanic isolation from other devices and wires.
Attention to thermal insulation of automation elements which can reach high temperatures (motors,
transformers, circuits implementing, heat sink etc.). For electrical connection see Fig. 1.
Factory wire antenna connected to antenna terminal. Optionally external antenna can be used. Connect external
antenna with 50Ω impedance coaxial cable to (
2. Receiver programming
2.1. Registering remote to receiver's memory
While holding receiver button press remote button.
LED blink. Selected button will control the output
channel of receiver. Any remote button can be
registered.
Registering another button does not erase
4
previously registered button.
Holding receiver button for more than 15
4
seconds will erase memory.
Attempt of registering 201 transmitter will
4
fail. LED will not blink.
2.2. Easy remote registering
Easy remote registering function allows registering
new remotes without access to receiver button.
Previously registered remote is needed.
press and hold for 15 seconds previously
4
registered remote button in receiver radio
range,
in no more than 3 seconds press and hold new
4
remote button for 15 seconds, new remote is
registered with the same active button as in the
previously registered remote.
Failure in registering may be caused by:
low battery of the remote,
4
radio interference during the procedure,
4
full memory of the receiver.
4
2.3. Easy remote registering function LOCK / UNLOCK
To protect receiver against unauthorized attempts of registering remote (important in access protected user
zones) easy remote registering function must be locked. To lock/unlock easy remote registering function:
turn off receiver power supply;
4
press and hold C1 button;
4
turn on receiver power supply;
4
While holding the button, C1 LED will alternately light on and light off every 5 seconds. To lock/unlock
4
easy remote registering release button when:
LED light on - easy remote registering locked,
LED light off - easy remote registering unlocked.
) terminal - center core, to (
1 1
PRESS AND HOLD
C1 BUTTON
Fig. 2. Remote button programming.
REMOTES IN RECEIVER RADIO RANGE
1 1
PRESS AND HOLD
FOR 15 SECONDS
ANY BUTTON
OF„OLD" REMOTE
Fig.3. Easy remote registering.
) terminal- shield.
2
3
BLINK
C1 LED
PRESS REMOTE
BLINK
BUTTON
THREE TIMES
2
PRESS AND HOLD
FOR 15 SECONDS
BREAK TIME
ANY BUTTON
MAX 3 SECONDS
OF „NEW" REMOTE
4
3x
C1 LED
BLINK