DTM System GALACTIC NANO 868 설치 매뉴얼 - 페이지 3
{카테고리_이름} DTM System GALACTIC NANO 868에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DTM System GALACTIC NANO 868 4 페이지. One channel radio receiver
페이지 인쇄2.4. Entering Galactic authentication code to NANO receiver
To enter an authentication code to receiver it is
necessary to have remote with programmed
authentication code.
To enter an authentication code to receiver press the C1
button twice. LED goes out for 8 seconds. During this
time press and hold for 5 seconds two buttons of the
remote. Successful entering of the code indicates the
C1 LED that blinks three times. From that moment the
r e c e i v e r h a s a u t h e n t i c a t i o n c o d e s e t a n d
programmable remotes with Galactic function can be
added.
If within 8 seconds after pressing C1 button twice, the
code is not entered, or code entering fails, the LED will
not blink three times but immediately light up.
2.5. Removing Galactic authentication code from NANO receiver
To remove the authentication code it is necessary to have a remote which the code has been entered.
To remove the authentication code press C1 button twice. LED goes out for 8 seconds. During this time press and
hold two buttons of the remote. Successful removing of the code indicates the C1 LEDs blink three times. If within
8 seconds after pressing C1 button twice, the code is not removed, or code removing fails, the LED will not blink
three times but immediately light up.
Memory format removes the authentication code from receiver.
2.6. Registering remote with Galactic function
To register remote with Galactic function
authentication codes of the receiver and remote must
be compatible.
To register remote press and hold for 5 seconds two
buttons of the remotes, in receiver radio range.
Successful registering indicates C1 LED blink three
times. To activate the remote at the receiver's
memory, press any button on the remote.
Failure in registering may be caused by:
incompatibility of authentication codes in
4
receiver and remote,
low battery of the remote,
4
radio interference during the procedure,
4
full memory of the receiver (attempt to
4
enter 201 remote).
1 1
2x
2
C1 LED
GOES OUT
PRESS AND HOLD
C1 LED
PRESS TWICE
GOES OUT
C1 BUTTON
FOR 8 SEC
ON THE REMOTE
Fig. 4. Entering Galactic authentication code.
REMOTE IN RECEIVER RADIO RANGE
1
PRESS AND HOLD
FOR 5 SECONDS
TWO BUTTONS
BLINK 3 TIMES
OF THE REMOTE
Fig. 5. Registering remote with Galactic function.
3
4
BLINK
3x
C1 LED WILL
FOR 5 SEC
BLINK 3 TIMES
TWO BUTTONS
CODE ENTERED
SUCCESSFULLY
BLINK
2
3x
PRESS ANY
C1 LED
BUTTON
TO ACTIVATE