ABSTRACT ClubScan 사용 설명서 - 페이지 3

{카테고리_이름} ABSTRACT ClubScan에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABSTRACT ClubScan 19 페이지.

Abstract Universal Instruction Manual

Connections and controls

All the units have the same connections and indications, though they are in

different positions on the different units. The main connections and controls

are as follows.

DMX output socket (pin 3 cold, pin 2 hot, pin 1 grounded). Other DMX

devices can be linked in to the system through this socket. In stand alone

mode the unit outputs its own DMX through this socket. If you're not sure

which is the input and the output, the input is the one where you can touch

the pins, the output is the one where you can't.

DMX input plug (pin 3 cold, pin 2 hot, pin 1 screen). A dedicated

controller such as the Abstract CE controller, or other DMX lighting desk

can be connected to this plug. The unit buffers the DMX signal, so you must

make sure you get the connectors the right way round. If you are using a

controller with a 5-pin DMX output, you will need to use a 5 to 3 pin

adaptor with pins 2 and 3 swapped.

Power on LED (red). This LED is lit whenever the unit is powered up. If

this light does not come on there is either no power to the unit, or some

internal problem with the unit.

DMX present / Audio beat LED (green). This LED is on

constantly when DMX is being received (it may flicker in time with the DMX

frames), and goes out when DMX is not received. When the LED is not lit the

unit is in stand alone mode and the LED will flash when an audio beat is detected.

Page 3

3 4