Auber Instruments SYL-1615SYS-W 빠른 매뉴얼 - 페이지 2

{카테고리_이름} Auber Instruments SYL-1615SYS-W에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Auber Instruments SYL-1615SYS-W 2 페이지. Charcoal smoker controller

페이지 인쇄

Press V key to change the display to END. Then, press SET to exit. You can also ignore the steps after confirmation of

SV. The controller will return to normal operation mode if no key is pressed for 1 minute. Figure 2 is a detailed flow chart

that shows how to set the SV.

Set the alarms.

The controller offers two alarms that can be set to turn on the buzzer at specific temperatures. The first alarm is controlled

by parameter AH1 and AL1. The initial setting will turn on the buzzer at 250° F and off when temperature drops below

249° F. The second alarm is controlled by parameter AH2 and AL2. The initial setting of the second alarm is deactivated. It

can be set as low alarm to send warning when charcoal is low.

AH1 and AH2 are the temperature to turn buzzer on; AL1 and AL2 are the temperature to turn buzzer off. When AH1(2) >

AL1(2), the alarm is set for absolute high alarm, When AH1(2) < AL1(2), the alarm is set for absolute low alarm, When

AH1(2) = AL1(2), the alarm is deactivated.

For example, if AH1 = 250, AL1 = 249, when the temperature goes up to 250° F, the buzzer will be on; when the

temperature drops down to 249° F, the buzzer will be off. If AH2 = 180, AL2 = 185, when the temperature drops down to

180° F, the buzzer will be on; when the temperature goes up to 185° F, the buzzer will be off.

User can press the shift key (>) to temporarily silence the buzzer sound alarm. The alarm will buzz again if the alarm set

temperature is reached again. To permanently deactivate the alarm, set AH1 = AL1 or AH2 = AL2. Please see flow chart

below on how to set the value.

Figure 2. Flow charge of how to set the target temperature (SV) and alarms.

(End)

No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent of Auber Instruments. Auber

Instruments retains the exclusive rights to all information included in this document.

Parameter Display

Operation Mode

Enter Code

SET

xxxx

0001

SET

Auber Instruments Inc.

5755 North Point Parkway, Suite 99,

Alpharetta, GA 30022

www.auberins.com

Email: [email protected]

Tel: 770-569-8420

Target Temp Selection

SET

0200

Buzzer On Temp

SET

0250

ah1

Buzzer Off Temp

SET

0249

al1

Buzzer On Temp

SET

0250

ah2

Buzzer Off Temp

SET

0250

al2

end

www.auberins.com

SET