Auber Instruments WS Series 빠른 매뉴얼 - 페이지 12

{카테고리_이름} Auber Instruments WS Series에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Auber Instruments WS Series 14 페이지. Programmable pid temperature controller with dual probe
Auber Instruments WS Series에 대해서도 마찬가지입니다: 빠른 매뉴얼 (15 페이지), 빠른 매뉴얼 (14 페이지), 작동 및 사용 설명서 (18 페이지), 작동 및 사용 설명서 (18 페이지)

페이지 인쇄

Note: All alarms can be cancelled during beeping by press the "-" key.

For details on how to use code 188 to access these parameters, please read section 7 of

the main manual.

9. Save and recall recipes

This controller can save up to 8 pieces of smoking recipe (programs). Each recipe file

can have up to 6 steps (C-1 to C-6). For convenience, we have pre-named these 8

pieces of recipe files as B1 (beef), B2, C1 (chicken), C2, F1 (fish), F2, P1 (pork), and P2.

These recipe files are all the same except their names, so you can store your special

recipe to any of them. These recipes can be stored in the memory of the controller even

when it is powered off. You can overwrite the exist recipe with a new one.

9.1 Save a recipe.

After a program has been entered, the user can save this current program as a recipe for

future use. Under the normal operating mode, press and hold SET key for 2 seconds

until the left window shows "LCK". The right window will show "0". Use the "+" or "-" key

to adjust the value to "2" (the passcode for saving the program) and then press SET key

to confirm. Then "SAV" will be shown on the left window and "End" on right window. If

press SET key now, you will exit this mode without overwriting any existing programs.

Use "+" or "-" key to select the name of recipe to which you want to store the program. If

you press "+" (or "-" key) repeatedly, you will see "End", "b1", "b2", "C1", "C2", "F1", "F2",

"P1", "P2" one by one. Press the SET key again to store your current program under the

selected recipe name. This process will overwrite the current recipe data to the saved

recipe data.

10. Recall a recipe.

WARNING: You current program will be overwritten by the selected recipe. Please write

it down somewhere if it is important to you. To recall a recipe, press and hold SET key for

2 seconds until the left window shows "LCK" and then release the SET key. The right

window will show "0". Use "+" key to adjust the number to "1" and then press SET. Then

"rC" (recall) will be shown on the left window and "End" on right window. This can prevent

your current program been accidently overwritten by a recalled program. Use "+" or "-"

key to locate recipe you want to recall. If you press "+" key repeatedly, you will see

"End", "b1", "b2", "C1", "C2", "F1", "F2", "P1", and "P2" one by one. After you locate the

recipe that you want to recall, press the SET key to select. Current program will be

overwritten by the selected program.

11. Single-step mode

In this mode, the controller will hold temperature at one set value (C-1) continuously as

long as the controller is powered on. Even if the controller is powered off and turned on