Auber Instruments WS Series 빠른 매뉴얼 - 페이지 14

{카테고리_이름} Auber Instruments WS Series에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Auber Instruments WS Series 14 페이지. Programmable pid temperature controller with dual probe
Auber Instruments WS Series에 대해서도 마찬가지입니다: 빠른 매뉴얼 (15 페이지), 빠른 매뉴얼 (14 페이지), 작동 및 사용 설명서 (18 페이지), 작동 및 사용 설명서 (18 페이지)

페이지 인쇄

normal operating mode and will start run the current program.

Store your program as recipe (Single-step Mode)

Before you input your set temperature, check the PrG = off (accessed by LCK code "3").

Press SET key once, and then set C-1=150, press set again to confirm and exit. The

controller will go back to the normal operating mode and start running on this single-step

program.

To store current program back to recipe b2, long press SET, set LCK=2, choose b2,

press set to confirm and exit. Now your current program is stored as recipe b2.

Recall your recipe to current program (Single-step Mode)

Before you input your set temperature, check the PrG = off (accessed by LCK code "3").

Long press SET, set LCK=1, choose b2, press set to confirm and exit.

Now the C-1 from the recipe b2 is recalled back to your current program. The controller

will start run at this temperature setting.

Advanced example

This example will show you how the PrG mode can affect the saved and current

recipe/program.

1) Set PrG = on, select "b1" recipe:

C-1=120, E-1=t, t-1=2.0;

C-2= 290, E-2= F, F-2=160;

C-3=130, E-3=t, F-3=30.0;

2) Change PrG = off, now the current single-step program is:

C-1: 120.

3) Set current C-1 to 200, then store current program back to recipe b1. Now the b1

recipe is:

C-1: 200.

4) Change PrG = on, current b1 recipe is:

C-1=200, E-1= t, F-1=2.0;

C-2=190, E-2=F, F-2=160;

C-3= 130, E-3=t, F-3=30.0.