AuCom CSX-022 사용자 설명서

{카테고리_이름} AuCom CSX-022에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AuCom CSX-022 13 페이지.
AuCom CSX-022에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

1.1

Caution Statements

Caution Statements cannot cover every potential cause of equipment damage but can highlight common

causes of damage. It is the installer's responsibility to read and understand all instructions in this manual prior

to installing, operating or maintaining the soft starter, to follow good electrical practice including applying

appropriate personal protective equipment and to seek advice before operating this equipment in a manner

other than as described in this manual.



Isolate the soft starter completely from the power supply before attempting any work on the starter

or motor.



Cables to the control inputs must be segregated from mains voltage and motor cabling.



Some electronic contactor coils are not suitable for direct switching with PCB mount relays. Consult

the contactor manufacturer/supplier to confirm suitability.



Do not apply incorrect voltages to the control input terminals.



Do not connect power factor correction capacitors to the output of CSX soft starters. If static power

factor correction is employed, it must be connected to the supply side of the soft starter.

The examples and diagrams in this manual are included solely for illustrative purposes. The information

contained in this manual is subject to change at any time and without prior notice. In no event will responsibility

or liability be accepted for direct, indirect or consequential damages resulting from the use or application of this

equipment.

WARNING - ELECTRICAL SHOCK HAZARD

CSX soft starters contain dangerous voltages when connected to mains voltage. Only a competent

electrician should carry out the electrical installation. Improper installation of the motor or the soft

starter may cause equipment failure, serious injury or death. Follow this manual and local electrical

safety codes.

GROUNDING AND BRANCH CIRCUIT PROTECTION

It is the responsibility of the user or person installing the soft starter to provide proper grounding

and branch circuit protection according to local electrical safety codes.

SHORT CIRCUIT

CSX soft starters are not short circuit proof. After severe overload or short circuit, the operation

of the soft starter should be fully tested.

Ce manuel est également disponible en français à partir de www.aucom.com.

Dieses Handbuch ist auch in deutscher Sprache aus www.aucom.com.

Questo manuale è disponibile anche in italiano da www.aucom.com.

Este manual también está disponible en español a partir de www.aucom.com.

该手册也可在中国从 www.aucom.com.

710-02407-00G

CSX

USER MANUAL

Page 1