Damp2Dry PACD150 사용자 설명서 - 페이지 14
{카테고리_이름} Damp2Dry PACD150에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Damp2Dry PACD150 16 페이지. 150 pint commercial dehumidifier
페이지 인쇄
- 1. Table of Contents
- 2. General Information
- 3. Important Safety Instructions
- 4. Structure Diagram
- 5. Setup Instructions
- 6. Setup Instructions
- 7. Control Panel
- 8. Control Panel
- 9. Operating Instructions
- 10. Maintenance
- 11. Maintenance
- 12. Troubleshooting
- 13. Error Codes
- 14. Purchase/Maintenance Records
WarnInG: DO NOT attempt to rectify errors using unqualified personnel.
To remedy the following errors, a qualified professional is required.
noTe: With any error code, it is suggested to turn the unit off, wait five
minutes, and then turn the unit on again. If the error code is still present, a
qualified professional is required to fix the problem.
CoDe
meanInG
E1
Coil sensor
error
E2
Humidity
sensor error
E3
Low or no
refrigerant
E4
Water pump
fault or
blockage
*NOTE: If the error occurs within one year from the date of purchase,
contact Consumer Services at 877-365-6274 for warranty assistance
prior to contacting a repair person. You must have the original
purchase receipt for warranty assistance.
error CoDes
DIsplay
reaDInG
Flashes every
30 seconds
Flashes every
30 seconds
Flashes
continually
Flashes
continually
-12-
soluTIon*
Replace coil sensor. Call for
replacement part.
Replace humidity sensor. Call
for replacement part.
Turn the unit off, wait 5
minutes, and power the unit
ON. If E3 shows again within
15 mins after turning the unit
back on, then we can confirm
the unit refrigerant leak
requires professional repair.
Call your local HVAC repair
shop for assistance.
Dehumidifier will turn OFF
automatically. Check for
blockages in the water hose. If
there are no visible blockages,
the pump or water pipe may
need to be replaced.