DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center 설치 매뉴얼 - 페이지 11
{카테고리_이름} DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center 19 페이지. Thunderbolt 3, dante, madi and adat modular analogue & digital audio interface
페이지 인쇄Installation Guide AX Center
Operation
AX Center is controlled from a Mac or Windows computer via the Thunderbolt connection or the Ethernet port
on the rear panel and configured by the DADman software running on the computer. On the front panel, you can
monitor some of the primary settings.
In the middle of the unit there are two Combo input XLR / ¼" jack connectors. The mode of each channel of the
two-channel input stage can be selected as the instrument input or the microphone input via DADman. The
selected mode is shown on the LED indicators next to the two connectors.
On the right side of the unit, there are two ¼" stereo jack connectors for headphones. The headphone level and
configuration is managed via the DADman software where the outputs can be attached as headphone monitor
outputs managed by the Pro|Mon monitor profile in the DADman software, enabling very flexible monitoring
configurations and well as integration to the DAD MOM monitor operation module and Avid Eucon™ for control
from Avid Eucon-enabled devices.
Front panel layout
1.
DAD Logo. Indicates that the unit is turned on and flashes while it is in standby (off)
2.
On/Standby button. Note that the unit automatically returns to the latest power state (on or standby)
if it is power cycled via the mains power.
3.
External sync source two-color indicator. Green LED shows that external sync source is OK, red LED
indicates that there is an insufficient sync signal.
4.
Internal sync indicator. Green LED shows internal or external sync source.
5.
Error indicator: Red LED. Indication is related to hardware performance and can be triggered by
temperature overload, fan error, DAD I/O card failure or general internal boot error. A more specific
error indication will be visible in DADman.
6.
Input mode for Mic/Inst connectors. Red LED shows Phantom Power and two Green LEDs show if
microphone or instrument input mode is selected
7.
Two mono Combo XLR and ¼" jack connectors for two channels of microphone or instrument input.
Microphone signals is connected balanced via the XLR connector and instrument input is connected
single ended via the jack input
8.
Two stereo and ¼" jack connectors for stereo headphone output
Doc no. AXCNTR-8001-A-4
Figure 6, Front panel layout
Rev. date 221023
Page 11 of 19