DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center 설치 매뉴얼 - 페이지 12

{카테고리_이름} DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAN NTP TECHNOLOGY DAD THUNDER CORE AX Center 19 페이지. Thunderbolt 3, dante, madi and adat modular analogue & digital audio interface

페이지 인쇄

Installation Guide AX Center

Rear panel connections.

Below is the layout of the rear panel of the AX Center,

Rear panel layout

1. Mains power connector.

2. "Reconfig" button. Please refer to the section below for further details.

3. Expansion slot for optional dual MADI I/O mini module via optical or coaxial SFP modules. The module

also supports our DADlink format.

4. RJ45 Ethernet connectors. Two ports for Control and Dante AoIP. Connectors can be set in switched or

redundant mode for Dante. In redundant mode the control network has to be connected to port 1.

5. Thunderbolt 3 interface for connection to a computer and for an expansion unit or other peripherical

interfacing.

6. Word Clock or Video Black Burst synchronization input (configurable), BNC connector, and Word Clock

output.

7. MADI I/O BNC connectors.

8. Two set of TOSLINK optical ADAT input and output connectors. Input can also be set to S/PDIF.

9. Two set of ¼ inch jack balanced outputs for left and right Monitor 1 and Monitor 2 outputs.

10. Slot 3 for Optional multi-format DAD I/O Cards (Slot 1 is the internal analogue card).

11. Slot 2 for Optional multi-format DAD I/O Cards (Slot 1 is the internal analogue card).

Doc no. AXCNTR-8001-A-4

Figure 7, Rear panel layout

Rev. date 221023

Page 12 of 19