DAN DRYER 244 Turbo 유지보수 및 서비스 매뉴얼 - 페이지 10

{카테고리_이름} DAN DRYER 244 Turbo에 대한 유지보수 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAN DRYER 244 Turbo 12 페이지.

Reference

Version

244-ENG

09-01-2018

Carbon brush replacement

Warning !!!

During cleaning and service the hand dryer

must always be disconnected from the

power supply.

1.Disconnect power supply.

2.Disassemble cover by removing the two

cover screws at the bottom of the housing.

Use the special Allen key which was

originally supplied with the hand dryer.

3. Disassemble angle bracket.

DAN DRYER A/S • Tåsingevej 2 • DK-8940 Randers SV • Tel: +45 86 41 57 11 • Email: [email protected]

Document

244 DAN DRYER Turbo (with nozzle)

Maintenance and service manual

Lang.

4. Loosen the 4 screws

on the fan housing and

disassemble fan

housing lid.

5. Gently lift up the motor.

Be careful not to damage

motor wiring.

6. Loosen carbon brush wiring.

7. Loosen the 2 x 2 screws,

allowing for the worn

brushes to be disassembled

from the motor.

8. Assemble new carbon

brushes and reassemble

screws and wires.

9. Reassemble all components

and test run hand dryer.

Page

ENG

10 of 12