DAN DRYER 244 Turbo 유지보수 및 서비스 매뉴얼 - 페이지 6

{카테고리_이름} DAN DRYER 244 Turbo에 대한 유지보수 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAN DRYER 244 Turbo 12 페이지.

Reference

Version

244-ENG

09-01-2018

Cleaning the inside of the machine

Warning !!!

During cleaning and service the hand dryer must always be disconnected from the power supply.

1.Disassemble cover by removing the two cover

screws at the bottom of the housing. Use the

special Allen key which was originally supplied

with the hand dryer.

Remove the

cover screws

2. Disassemble angle bracket by removing the

screw (A)

(A)

3. Remove the four screws (B). Disassemble the

top half of the motor housing

(B)

DAN DRYER A/S • Tåsingevej 2 • DK-8940 Randers SV • Tel: +45 86 41 57 11 • Email: [email protected]

244 DAN DRYER Turbo (with nozzle)

Maintenance and service manual

Remove the

cover screws

(B)

Document

4. Carefully lift up the motor whilst taking note

how the motor was positioned inside the

housing and how the motor wires are placed in

the protective grooves (C)

5. Disconnect motor wires from the timer unit

(appearance depends on the timer type).

Place the motor on a table upside-down.

6. Check whether carbon brushes are worn down

and need to be replaced. If so, disassemble by

removing the screws and by disconnecting

wires from carbon brush terminals.

Lang.

Page

ENG

6 of 12