ADDER AdderLink X-DVIPRO 매뉴얼 - 페이지 6

{카테고리_이름} ADDER AdderLink X-DVIPRO에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADDER AdderLink X-DVIPRO 15 페이지. Adder pro dvi
ADDER AdderLink X-DVIPRO에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (16 페이지)

페이지 인쇄

Installation

Connections

Installation of the X-DVIPRO and X-DVIPRO-MS2 modules is straightforward and

requires minimal configuration in most cases.

•

Connections at the local module

•

Connections at the remote module

Note: After all connections are made, power up the monitor and the REMOTE

module first (followed by the LOCAL module, if using the X-DVIPRO-MS2

variant) and then switch on the computer.

Mounting the modules – desk or rack

The X-DVIPRO and X-DVIPRO-MS2 modules can be situated on a desk or

alternatively, for larger installations, mounted within an optional rack mount

chassis.

Desk mount

Apply the supplied self-adhesive rubber

feet to the underside of the module.

Rack mount

1 Place the rack securing plate (available as a separate kit) onto the front of the

module and secure it with the two countersunk screws.

2 Orient the X-DVIPRO (or X-DVIPRO-MS2) module on its side so that its

labelled face is the correct way up.

3 Slide the module into the required rack position. The rectangular cut-out in

the front upper lip of the rack allows the two screws on the module's upper

edge to slide through.

4 The rack mount chassis has a series of holes in its floor that are spaced to

accommodate the two screws on the module's lower edge. Ensure that

the screws correctly locate into the two holes of the chosen slot. The rack

securing plate on the module should now be flush with the front of the

rack mount chassis.

5 Use the third (pan-head) screw, in the top hole of the rack

securing plate to fasten the module to the rack.