ADDER AdderLink X-DVIPRO 매뉴얼 - 페이지 8

{카테고리_이름} ADDER AdderLink X-DVIPRO에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADDER AdderLink X-DVIPRO 15 페이지. Adder pro dvi
ADDER AdderLink X-DVIPRO에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (16 페이지)

페이지 인쇄

4 Connect the link cable (see page 2 for cable advice) to the local module

socket labelled

TO REMOTE

CATx link cable

[MS2 variant only] Attach a

second category 5e, 6 or 7a

link cable (up to 60 metres in

length) to the upper socket on

the MS2 local module.

Secondary CATx link cable

Primary CATx link cable

Power connection

The X-DVIPRO local module is designed to derive its power from the host

computer via the USB connection (two USB connections in the case of the MS

version). If this is not possible, then you will need to use one or two optional

Adder power adapter(s).

Optionally for X-DVIPRO and X-DVIPRO-MS2 units:

1 Connect the output lead of the

optional power adapter(s) to the

socket(s) labelled '

' on the local

POWER

module.

X-DVIPRO: Use an optional

power adapter only if

powering from the host

(via USB) is not possible.

Note: After all connections

are made, power up the

monitor and the REMOTE

module first (followed by

the LOCAL module, if using

the X-DVIPRO-MS2 variant

with power adapters)

and then switch on the

computer.

X-DVIPRO-MS2: Use two

optional power adapters

if powering from the host

(via dual USB connections)

is not possible.

2 Insert the IEC connector of the separate power lead(s) into the

corresponding socket(s) of the power adapter(s). Connect the other end of

the power lead(s) to one/two nearby mains socket(s).

Do not use squid cables or

power splitters. Two separate

power adapters must be used.