concept 2 DYNO 조립 지침 매뉴얼 - 페이지 9

{카테고리_이름} concept 2 DYNO에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. concept 2 DYNO 12 페이지.

16a. Route the Monitor Cable through the center

hole in the Monitor Assembly.

16c. Plug the wire into the Monitor.

17b. Route the free end of the coiled cable through

the fitting. Re-attach the Fitting to the Flywheel

Assembly and connect the two plugs.

11/01

16b. Attach the Monitor Assembly to the top of the

Mast using the two 1/4" by 21/2" screws and

two 1/4" nuts. It doesn't matter which way you

insert the bolts.

17a. Remove the Strain Relief Fitting on the bottom

of the monorail extension of the Flywheel

Assembly.

Pull Side Seat Back

18. Assemble the Seat Backs to the Seat Back

Brackets. Use two 3/8 " by 7/8" screws for each

Seat Back. Note that the more rounded end of

the Seat Back is the top.The height of the seat

back can be adjusted by the choice of mounting

holes used. We suggest starting with the middle

setting on the pull side, and the highest setting

(lowest holes) on the push side. Reposition the

seat backs according to the user's height if

necessary.

Push Side Seat Back