3onedata IES605-2D series 사용자 설명서 - 페이지 13

{카테고리_이름} 3onedata IES605-2D series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3onedata IES605-2D series 17 페이지.

laying position need to match construction requirements,

and cable length depends on actual position;

4. All the cable cannot have break-down and terminal in the

middle;

5. Cables should be straight in the hallways and turning;

6. Cable should be straight in the groove, and cannot beyond

the groove in case of holding back the inlet and outlet holes.

Cables should be banded and fixed when they are out of the

groove;

7. User cable should be separated from the power lines.

Cables, power lines and grounding lines cannot be

overlapped and mixed when they are in the same groove

road. When cable is too long, it cannot hold down other

cable, but structure in the middle of alignment rack;

8. Pigtail cannot be tied and swerved as less as possible.

Swerving radius cannot be too small (small swerving causes

terrible loss of link). Its banding should be moderate, not too

tight, and should be separated from other cables;

9. It should have corresponding simple signal at both sides

of the cable for maintaining.

【Specification】

Technology

Standard: IEEE802.3, IEEE802.3u, IEEE 802.3x,

Protocol: ARP, ICMP, TCP, UDP, DHCP, DNS, HTTP,

SW-Ring

Flow control: IEEE802.3x, back pressure control

Function

Function: SW-RingTM, Broadcast storm control, flow statistics,

upgrade online, up and download configuration file, user name

access system.

SW-Ring

: Single, Couple, Chain, Dual homing ring.

Serial device server: 4 port serial device sever, each port

Support 4pcs TCP or UDP session connection