Ducati PERFORMANCE 979000152 매뉴얼 - 페이지 13

{카테고리_이름} Ducati PERFORMANCE 979000152에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ducati PERFORMANCE 979000152 16 페이지. 999-749 magnesium headlight mounts kit

Abbagliante

Anabbagliante

VERSIONE USA

Anabbagliante

Abbagliante

Fit the low beam lamp (8) into the lower part of the left

headlamp mount (9).

Note

The low beam lamp can be identified thanks to a satin-

finished ring on the glass surface.

Start screws (4) into their threads working from outside the

headlamp mount to fix the headlamp (8). Then tighten screws to

the specified torque (Sect. C3).

Fit the high beam lamp (19) into the upper part of the left

headlamp mount.

Start screws (4) into their threads working from outside the

headlamp mount to fix the high beam headlamp (8).

Then tighten screws to the specified torque (Sect. C3).

Warning

When working on USA version, take care to fit headlamps in

reverse position. The low beam lamp must be fitted in the upper

part of the headlamp mount and the high beam lamp must be

fitted in the lower part.

Position the front wiring (20) to the left headlamp mount (9), as

shown in the figure.

Insert the connector (21), identified by the wording "AB" on the

high beam lamp (19).

Insert the connector (22), identified by the wording "AN", on the

low beam lamp (8).

Route the instrument panel (23), left front turn indicator (24), right

front turn indicator (25) and parking light (26) wiring branches.

To fit the fuse box (27) on the right headlamp mount (3) as shown

in the figure, start screws (28) into their threads.

Tighten screws (28) to the specified torque (Sect. C3).

Insert connector (29) into air temperature sensor (30) and install

the light relay (31) into the special rubber cap (32).

Cod. ISTR-77UK

Pag. 5/8