Anyload EC200 사용자 설명서 - 페이지 8

{카테고리_이름} Anyload EC200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anyload EC200 8 페이지.
Anyload EC200에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

7.3 Scale 3 Calibration:

Connect the extra platform through DB9.

SCALE3 DB9

S-

S+

3/6 V+

V-

GND

7~9 NC

Turn on the scale, and then press <1>, <3>, <1>, <3>, <Enter> when the scale

examining itself.

7.3.1 Menu setting:

'WEIGHT display' shows

'UNIT WEIGHT display' shows CAP XXXX.

'TOTAL display' will show d=X.X.

Then press <UNIT> button to select calibration unit between kg and lb，Press <CE>

button and then press 'number buttons' to set the max calibration value，press<*>

key to select division，press <Enter> key to confirm。

7.3.2 Calibration:

Make sure nothing loaded on the external platform.

Press <Enter> to set zero point. (UNIT WEIGHT display will show CAL-0 flashing

for a few seconds and then changes to XXXX to set the Calibration weight).

Press <CE> button and then press <NUMERIC (0-9) KEY> to set the calibration

weight. Calibration weight will show on the UNIT WEIGHT display. Put the test

weight on the external platform. Press <ENTER> button, the UNIT WEIGHT display

will show a flashing XX then change to XX.XXX lb. Then the Calibration procedure

complete.

7.3.3 Check Calibration:

Reboot the scale. Place test weight on the scale and see the weight is correct or

not. If not, please redo the above Calibration procedure.

Page 8 of 8

SCALE3,

Load cell DB9

S-

S+

V+

V-

GND

6~9 NC

AL-Manual-EC200-En-101