Anyload A1A 제품 설명서 - 페이지 3
{카테고리_이름} Anyload A1A에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anyload A1A 5 페이지. Load cell amplifier
1.
Introduction
Thank you for choosing Anyload A1A load cell amplifier. A1A strain gage
amplifier provides load cell and transducer signal conditioning. It is designed for
converting mV signal from load cell output into a 4~20mA or 0~10V signal. The
A1A strain gage amplifier is DC powered and can drive up to 2 x 350Ω load cells
or 4 X 700Ω load cells. It can be connected directly to 1 load cell or to several
load cells through a junction box. The amplifier is housed in an aluminum
casting enclosure and has 2 through holes for easy installation. This manual
provides the installation, operation and calibration procedures of the product.
2.
Installation
Only simple tools like small size slotted screw driver and Philips screwdriver are
required for connecting cables during installation, adjusting the unit during
calibration and installation of enclosure cover.
3.
Connection Diagram
From Amplifier to 24V DC Power and 0~10V/4~20mA output signal:
Vo: Output Voltage Signal 0~10V
Io: Output Current Signal 4~20mA
Vs: Input 24V DC Power
GND: Ground
2 |
ANYLOAD A1A Amplifier Product Manual (V1611)
Fig1.Connection Diagram