AnyLoadg P1 사용자 설명서 - 페이지 6
{카테고리_이름} AnyLoadg P1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyLoadg P1 8 페이지. Weighing indicator
페이지 인쇄2. General Configuration
In this chapter, this manual will guide you how to configure the P1
indicator.
Press
to enter Configuration Mode.
Press "
"and"
"Key to switch menu from F1 to F9.
Press
to enter setting.
F 1: Peak Hold
P 0 ------Enable Peak Hold;
P 1 ------Disable Peak Hold;
F 5: Filter Setting
FLT 0~ FLT 7---It's recommended to set the filter to 1 when calibrating
and 4 when the indicator is in the normal Weighing Mode.
F9: Calibration
Press
when indicator shows F9 to enter Calibration.
The indicator will show P 000 after entering calibration, which means
there is a 3 digits password required to enter the setting. Press
move right and press "
The default password is 111.
Indicator will show S Menu after entering Calibration. Press
"
"and"
"Key to switch S menu from S1 to S9.
S1: Display Divisions
User can choose from 1,2,5,10,20,50,100.
S2: Decimal Point Position
User can choose from 0,1,2,3,4
S3: Capacity
Specify the capacity of the scale. User can edit the number.
S4: Test weight
Specify the test weight on the scale to calibrate the indicator.
W
"and"
to edit the number.
> D
^ t> W
to