AnyLoadg P1 사용자 설명서 - 페이지 5
{카테고리_이름} AnyLoadg P1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyLoadg P1 8 페이지. Weighing indicator
페이지 인쇄1.5 Battery
Scale
Battery Type
Trust Fire RCR123A
Lithium Battery
Charger
Lithium battery
Charge Time
8hours
(Approximately)
Work Time
24 hours
Charger
100~240VAC 50/60Hz
Power supply
1.6 Error Message
Err 05
Wireless communication is abnormal, check the antenna and the power
supply of both indicator and the scale.
--OV--
Overload, if there is not weight on the scale, the wire connection
between the load cell and the wireless module.
dC LL
Indicator low battery, please recharge the indicator with NC1056
recharger.
L ----
Scale low battery, please recharge the scale battery with lithium battery
charger.
1.7 Installation Of The Scale
Unscrew the battery cap, replace the flat batteries with the fresh ones, make
sure the batteries are installed properly before tightening the battery cap. The
negative of the battery is facing the battery cap.
The scale body will turn off after one hour without operation. If you want to use
again, please turn it off before turn it on again.
W
Indicator
7.2V 2800mAH Ni-MH
battery
NC1056
4 hours
40 hours (without backlight)
100~240VAC 50/60Hz
> D
^ t> W