AnyTone AT-500M 사용 설명서 - 페이지 7

{카테고리_이름} AnyTone AT-500M에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AnyTone AT-500M 13 페이지. 10 meter radio

페이지 인쇄

3.8 VOX function .....................................................................................

The VOX function allows transmitting by speaking into the original

microphone without pressing the PTT switch.

Press [PTT] + [EMG] key to activate VOX function, LCD displays

microphone icon, and then press [PTT] + [EMG] key to disable VOX

function. The microphone icon disappeared.

Note: When turn on VOX, the mic icon flashes, VOX sensitivity and time

setting refer to page 6.

3.9 PA Function .......................................................................................

This function allows you to select the mode of operation for public

broadcasting.

Turn on PA mode: "PA" and modulation mode (AM/FM) flicker alternately.

The volume switch knob is used to adjust the audio level of mode PA.

3.10 Talkback Level ...............................................................................

This function allows you to adjust the volume of your walkie-talkie.

(1)

Start the intercom function (see "intercom" on page 8).

(2)

Hold down the PTT switch, then the [up] key increases or the [down] key

decreases the Talkback Level

(3)

Release PTT switch and save Talkback Level.

3.11 Norms Control ................................................................................

(1)

Hold

to power on radio, until LCD displays the norms.

(2)

Short press

(3)

Power off and power on again.

3.12 Install External Speaker ..............................................................

Choose a 8Ω external speaker with 3.5 mm mono connector.

3.13 Menu Operations ..........................................................................

(1)

Long press

Short press microphone [ UP ] or [ DN ] or

(2)

to be.

(3)

Short press

function, the parameter blinks on LCD.

Short press microphone [ UP ] or [ DN ] or

(4)

wanted setting.

or microphone [UP ]/[DN].

key to enter menu list.

key to enter function setting parameter of the chosen

to choose menu

to choose

AT-500M