3onedata NP30XT series 사용자 설명서 - 페이지 4

{카테고리_이름} 3onedata NP30XT series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3onedata NP30XT series 20 페이지. Serial device server

CHAPTER 1 Access to Serial server serial device server

The CLI user manual compliant with the products as follows:

NP302-2D(RS-232),

NP302-2D(RS-485),

NP304-4D(RS-232),

NP304-4DI(RS-485),

NP308-8D(RS-232),

NP308-8DI(RS-485),

NP3016-16D(RS-232), 16 port RS-232 to Ethernet;

NP3016-16DI(RS-485), 16 port RS-485/422 to Ethernet;

1.1

Terminal device use telnet connect to Serial server through PC, the requirements are as follows:

1. The IP address of Serial server, can get it by search or modify (Use IP command under the system management

view);

2. If PC and serial device server in the same local area network, the IP address must in a same network segment,

otherwise, PC and serial device server must cross-router.

If satisfied these two requirements, can use telnet access to serial device server, and then configure the serial

device server.

1）Establish configuration environment, just connect PC 's Ethernet port connect to serial device server's

Ethernet port through Local area network

2）Before access Serial server through Telnet, need to input"Telnet+ Space+ serial server's IP address" for

checking, Figure 1.1.1 as follows:

3）Hit "Enter", checkout successful and till PC show"Please input hostname and password", ask user to input

user name and password, default is admin, figure 1.1.2 as follows:

2 port RS-232 to Ethernet;

2 port RS-485/422 to Ethernet;

4 port RS-232 to Ethernet;

4 port RS-485/422 to Ethernet;

8 port RS-232 to Ethernet;

8 port RS-485/422 to Ethernet;

（Figure 1.1.1）

（Figure 1.1.2）

Page1

CLI user manual