Duerkopp Adler 550-12-12 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Duerkopp Adler 550-12-12에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 550-12-12 6 페이지.
Duerkopp Adler 550-12-12에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

페이지 인쇄

3. Electrical Connection

3.1 Checking the Nominal Voltage

3.2 Checking Positioning

ATTENTION !

All work on the electrical components of the sewing unit may only be

conducted by electricians or appropriately trained personnel.

The mains plug must be pulled out.

The nominal voltage listed on the motor rating plate of the sewing

drive and the mains voltage must be the same !

The machine should position when the thread pulling lever is at its

upper dead center.

The setting of the positioning is usually made at the factory.

Checking positioning

–

Turn off the main switch.

–

Bring the thread pulling lever into a central position by turning the

handwheel 2.

–

Turn on the main switch. The machine positions.

If the thread pulling lever is not in its upper dead center then the

position must be reset.

Setting the position

–

Loosen the threaded pins 1 of the synchronizer ring 3.

–

Firmly hold the synchronizer ring 3.

–

Move the thread pulling lever into its upper dead center by turning

the handwheel 2.

–

Tighten the threaded pins 1 again.

–

Check the positioning again.