Danby DDW1805 서비스 매뉴얼 - 페이지 8
{카테고리_이름} Danby DDW1805에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danby DDW1805 15 페이지. Dishwasher division 22 461
Danby DDW1805에 대해서도 마찬가지입니다: 서비스 매뉴얼 (16 페이지), 서비스 매뉴얼 (12 페이지)
페이지 인쇄
Figure 1
3. Remove the screws which locking the control panel (See figure1). Remove the knob and
unscrew the two screws which locking the timer on the control panel. (See Figure 2.)
4. Take down the damaged timer and install a new timer, reverse procedures to complete
repairs. (See figure 3and 4.)
Figure 3
DOOR LATCH AND SWITCH ASSEMBLY
The latch and switch are located in the door assembly behind the control panel. The
dishwasher will not operate until the door is closed; the latch engages the door catch.
To Test Or Replace Door Switch.
1. Disconnect dishwasher from electrical supply.
2. Remove screws securing the control panel to the inner door (See Figure 1).
3. Remove wire leads from latch switch.
4. Use ohmmeter and check switch for continuity.
5. If the switch tests is good.
Check dishwasher electrical power.
Check to see if timer is defective.
If switch is defective remove door switch from latch assembly.
6. Install new switch and reverse procedures to complete repairs.
To Replace Door Latch Assembly
1. Disconnect dishwasher from electrical supply.
2. Remove screws securing the control panel to the inner door.
3. Remove wire leads from door latch and remove screws securing door latch assembly to
inner door. (See Figure 5.)
Figure 2
TIMER
Figure 4