Danby DDW1805 서비스 매뉴얼 - 페이지 9
{카테고리_이름} Danby DDW1805에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danby DDW1805 15 페이지. Dishwasher division 22 461
Danby DDW1805에 대해서도 마찬가지입니다: 서비스 매뉴얼 (16 페이지), 서비스 매뉴얼 (12 페이지)
페이지 인쇄
DOOR
LATCH
Figure 5
4. Install new door latch assembly and reverse procedures to complete repairs.
FLOAT SWITCH ASSEMBLY
The water float assembly is located in the right lower side of the dishwasher (the
portable located behind the lower front crosspiece). When too much water enter
the dishwasher，the water will enter the float support through the overflow pipe,
the float will make the floating switch acts, the electrical supply to the water valve
will disconnected and the drain pump keep on working.
If the switch fails to operate, check the following:
Loose connection at the switch terminal.
●
Switch not installed properly.
●
Warped stem on float, not contacting the actuator blade.
●
Float support restricts free float movement.
●
Check if the float support is cracked.
●
Food or foreign material restricting free float movement.
●
If the rubber cap lost(See figure7).
●
RUBBER CAP
To Remove Or Replace Float Switch
1. Disconnect dishwasher from electrical supply.
2. Remove electrical leads to float switch.
3. Take down the switch from float support.
4.
Install new float switch and reverse procedures to complete repairs (See figure 6).
SCREW
WIRE
LEAD
SWITCH
Figure 7
FLOAT SWITCH
Figure 6
WIRE LEAD